Home > Scan > Scan Using the Scan Button on Your Fuji Xerox Machine > Scan Photos and Graphics

Scan Photos and Graphics

Send scanned photos or graphics directly to your computer. Fuji Xerox's ControlCenter software will launch the default graphics application on your computer and open your scanned document automatically.

Use the Scan button on the machine to make temporary changes to the scan settings. To make permanent changes, use Fuji Xerox's ControlCenter software.

DocuPrint M225 dw/DocuPrint M225 z
DocuPrint M265 z

DocuPrint M225 dw/DocuPrint M225 z

  1. Load your document.
  2. Press (Scan).
  3. Press or to select the Scan to PC option, and then press OK.
  4. Press or to select the Image option, and then press OK.
  5. If the machine is connected over the network, select the destination computer.
  6. Press OK.

    If the LCD prompts you to enter a PIN, enter the four-digit PIN for the destination computer on the LCD.

  7. Do one of the following:
    • To change the scan settings for this document, press or to select Yes, and then press OK. Go to the next step.
    • To use the default scan settings, press or to select No, and then press OK. Press Start.

      The machine starts scanning. If you are using the machine's scanner glass, follow the LCD instructions to complete the scanning job.

    • In order to change scan settings, Fuji Xerox's Control Center software must be installed on a computer connected to the machine.

  8. Select the scan settings you want to change:
    • Scan Type
    • Resolution
    • File Type
    • Scan Size
    • Remove Bkg. Clr

      (available only for the Color and Gray options.)

  9. Press Start.
    The machine starts scanning. If you are using the machine's scanner glass, follow the LCD instructions to complete the scanning job.

DocuPrint M265 z

  1. Load your document.
  2. Press Scan>to Image.
  3. If the machine is connected over the network, press or to display the computer where you want to send data, and then press the computer name.

    If the LCD prompts you to enter a PIN for the computer, enter the four-digit PIN on the LCD and then press OK.

  4. Do one of the following:
    • To change the scan settings, press Options, and then go to the next step.
    • To use the default scan settings, press Start.

      The machine starts scanning. If you are using the machine's scanner glass, follow the LCD instructions to complete the scanning job.

    In order to change scan settings, Fuji Xerox's Control Center software must be installed on a computer connected to the machine.

  5. To scan both sides of the document (DocuPrint M265 z):
    • Press 2-sided Scan, and then select the document type.
    Option
    Description
    2-sided Scan: Long Edge
    2-sided Scan: Short Edge
  6. Select the scan settings you want to change:
    • Scan Type
    • Resolution
    • File Type
    • Scan Size
    • Remove Background Colour

      (available only for the Colour and Grey options.)

  7. Press OK.
  8. Press Start.
    The machine starts scanning. If you are using the machine's scanner glass, follow the LCD instructions to complete the scanning job.
Related Information

Go to top of page